User Tools

Site Tools


machine_debug:printing_setting

Set up the printer after installation

1. Check the machine voltage after installation.

2.Select Language

Click the front button to turn on the computer, and select the desired language after turning it on.

3.Enters the POST

4.Bed Leveling

Click ‘Maintenance’—'Bed leveling’


Adjust the nut under the four corners of the platform in turn so that the distance between the nozzle and the platform is in the thickness of a piece of paper. After leveling, the interface displays a measured reference flatness of the platform.

5.Set Zoffset

Click ‘Maintenance’—'Z Offset’

click the upper and down icon the nozzle will move up and down, make the distance between the nozzle and the platform is in the thickness of a piece of paper, save the parameters.


6.Load filament

Straighten the filament and insert it into the nozzle. Click the filament feed icon.

7.Printer test file

Insert the TF card into the right side of the printer and print the test file in the TF card.

machine_debug/printing_setting.txt · Last modified: 2020/09/22 08:18 by peter